RATIONALE FOR SETTING LUNETTES PROFILE CUTTING BLANKS

Authors

  • М. М. Марчук National University of Water and Environmental Engineering
  • Н. М. Марчук National University of Water and Environmental Engineering
  • І. Б. Гевко Ternopil Ivan Pulіuі National Technical University
  • Р. В. Комар Ternopil Ivan Pulіuі National Technical University
  • В. М. Клендій Ternopil Ivan Pulіuі National Technical University

Keywords:

lunette, harvesting, technological process, bearing, bushing, tool carriers

Abstract

It is offered the lunette construction for cutting horizontal workpieces characterized by the fact that the lunette displacement node is designed as the thrust and radial bearing, and in its inner diameter there is located the sleeve pipe with the profile similar to crosssection of theprofile  workpiece with the possibility of axial displacement with the cylindrical rolling bodies which  interact with the surface of the workpiece. Besides, the cut-off biteis fixed in the cutter carrier and the special shaped cutter is fixed in the additional cutter carrier. There are specified the analytical dependences for determining the cutting force for rods with the consideration of friction forces and other additional factors of the device. The paper offers the graphical dependenceofthe workpiece pressure forces on the roller at different values of the workpiecelinear length.

Author Biographies

М. М. Марчук, National University of Water and Environmental Engineering

Candidate of  Engineering, Professor

Н. М. Марчук, National University of Water and Environmental Engineering

Assistant

І. Б. Гевко, Ternopil Ivan Pulіuі National Technical University

Doctor of Engineering, Professor

Р. В. Комар, Ternopil Ivan Pulіuі National Technical University

Candidate of Engineering, Associate Professor

В. М. Клендій, Ternopil Ivan Pulіuі National Technical University

Candidate of Engineering

References

Корсаков В. С. Основы конструирования приспособлений в машиностроении. – М., 1971.

Технология машиностроения / Егоров М. Е. и др. – М., 1976.

Справочник технолога-машиностроителя. В 2-х т. [Текст] / под ред. А. Г. Косиловой и Р. К. Мещерякова. – М. : Машиностроение, 1985.

Колев К. С. Технология машиностроения. – М., 1977.

Пат. 98902 Україна, МПК (2006.01) B 65 G 33/14. Люнет для відрізаня профільних заготовок / Гевко І. Б., Білик С. Г. Кучвара І. М., Диня В. І., Фльонц О. В. заявник та па-тентовласник Гевко І. Б., Білик С. Г. Кучвара І. М., Диня В. І., Фльонц О. В. – № u 2014 12902; заявл. 02.12.14; опубл. 12.05.15, Бюл. № 9.

Павлище В. Т. Основи конструювання та розрахунок деталей машин / В. Т. Павлище. – К. : Вища школа, 1993. – 556 с.

Published

2016-06-22

Issue

Section

Статті